What is frequency in IP SLA?

      Comments Off on What is frequency in IP SLA?

What is frequency in IP SLA?

The ICMP Echo probe sends an ICMP Echo packet to next-hop IP 2.2. 2.2 every 3 seconds, as defined by the “frequency” parameter. Timeout sets the amount of time (in milliseconds) for which the Cisco IOS IP SLAs operation waits for a response from its request packet.

What is IP SLA enable reaction alerts?

To enable Cisco IP Service Level Agreements (SLAs) notifications to be sent to all registered applications, use the ip sla enable reaction-alerts command in global configuration mode. To disable IP SLAs notifications, use the no form of this command.

How do I clear IP SLA?

IP SLA- How to Restart or Clear Counters of IP SLA Statistics

  1. R1(config)#ip sla monitor restart 1 >>>>> where “1” is Entry number.
  2. R1(config)#ip sla restart 1 >>>>> where “1” is Entry number.
  3. Round trip time (RTT) Index 1Latest RTT: 2 milliseconds.
  4. Round trip time (RTT) Index 1Latest RTT: 2 milliseconds.

How do I run IP SLA?

Defining and Running an IP SLA Test Operation

  1. Step 1: Enable the IP SLA Responder on the Target Switch. Switch(config)# ip sla responder.
  2. Step 2: Define a New IP SLA Operation on the Source Switch.
  3. Step 3: Select the Type of Test Operation to Perform.
  4. Step 4: Schedule the Test Operation.

How to close ICMP-echo in IP SLAs mode?

Close icmp-echo To configure an IP Service Level Agreements (SLAs) Internet Control Message Protocol (ICMP) echo operation, use the icmp-echo command in IP SLA configuration mode. icmp-echo {destination-ip-address| destination-hostname}[source-ip{ip-address| hostname}| source-interfaceinterface-name]

What should the range be for IP SLAs Echo?

Defines an Echo operation and enters IP SLA Echo configuration mode. (Optional) Sets the hexadecimal value for data pattern. The range is 0 to FFFFFFFF. (Optional) Sets the number of history buckets that are kept during the lifetime of an IP SLAs operation.

How to use ICMP-echo through probe-packet priority?

Chapter: icmp-echo through probe-packet priority Chapter Contents icmp-echo icmp-jitter interval (LSP discovery) interval (params) ip-address (endpoint list) ip sla ip sla auto discovery ip sla auto endpoint-list ip sla auto group ip sla auto schedule ip sla auto template ip sla enable reaction-alerts ip sla ethernet-monitor

Which is the configuration mode for IP SLAs?

Begins configuration for an IP SLAs operation and enters IP SLA configuration mode. Defines an ICMP Echo operation and enters IP SLA ICMP Echo configuration mode. (Optional) Sets the rate at which a specified IP SLAs operation repeats.